AM335x based System on Module- FIAMMA

AM335x based SoM FIAMMA processor offered by Embien is the best cost optimized solution for industrial applications from the proven Texas Instruments processor family Sitara™AM335x ARM Cortex™-A8. FIAMMA module integrates common interface peripherals and display capabilities, along with options for graphics acceleration and Industrial Ethernet capabilities. This AM335x based SoM GHITA is suitable for applications such as: Industrial Communication, Factory Automation, Grid Infrastructure, Connected Industrial Drives, Smart Energy Concentrations, Electronics point-of-sale devices etc.,
Specifications
CPU
  • CPU Name – Texas Instruments AM335x Sitara™ Family
  • CPU Type – ARM® Cortex™-A8
  • Cores – x1
  • CPU Clock – up to 1GHz
  • PRU – The PRU and application software for AM3359 is available
Display
  • Video out – TTL RGB 24bit, up to 2048×2048, dot clock up to 126MHz
  • Touch Panel Interface – Resistive, 4 wire
Audio
  • Audio Output – Integrated Stereo Codec with Programmable Gain
  • Audio Input – Integrated Stereo Codec with Programmable Gain
Multimedia
  • Graphic accelerator – 2D/3D graphic accelerator with PowerVR SGX530
Memory
  • Cache – L1: 32KB Instruction, 32KB Data – L2: 256KB with ECC
  • RAM – 512MB-1GB- DDR3 – 606Mb/s
  • FLASH – 256, 512 M Byte – NAND
Networking
  • Ethernet – x1 Fast Ethernet (10/100), x1 Gbit Ethernet (10/100/1000) RGMII
  • Wi-Fi – 2.4 / 5GHz, 802.11 b.g.n. antenna connector or internal chip antenna
  • Bluetooth – Bluetooth 2.1+EDR class 1.5, Bluetooth 4.0 BLE
  • ANT – ANT ready
Mechanical specifications
  • Dimensions (W x L x H)- 60mm x 80mm x 7mm (not including debug connector)
Electrical specifications
  • Module Power Supply – 5V, 1-3W depending upon the configuration
  • I/O Power Supply – 1.8V – 3.3V
Environmental Specifications
  • Commercial Temperature Range – 0 to 70°C
  • Extended Temperature Range - -40 to +85°C
Longevity
  • Minimum availability – 2024
Software
Block Diagram
Dev kit
Enquiry

AM335x based SoM FIAMMA offers two hardware development tools for Industrial Automation and a power consumption of only 7 MW in stand-by-mode. It enables industries to reduce cost by allowing them to remotely control and monitor machineries. FIAMMA module helps utilize device connectivity to control, diagnose, repair and communicate with equipments such as PLC’s, robots, process control equipment, and so on in an effective way.

Accelerate your project development with Embien

Looking for expert advise?